Serial Port Mode Configuration - Bolin Technology EX1030BHD-L5NA User Manual

system time will be updated as the settings on the central management server. In addition, all settings, except the
following, will be restored to factory defaults: network interface card, server, image, OSD, privacy mask, custom
information, and ROI.
•
Registration will fail if the device ID is different from that stored on the central management server. You need to
restart the camera in order for the registration to succeed.
•
If the camera operates independently, select None for Protocol.
Connect via the Private protocol
1. Click Setup > Common > Server, and then
click the Management Server tab.
2. In the Device ID text box, enter an ID that is
unique in the network.
3. Select Private from the Protocol drop-down
list.
4. Enter the correct IP address and port number
for the central management server.
5. Click Save.

Serial Port Mode Configuration

The RS485 serial port is used for data exchange with the third-party device. Serial port settings on the camera should
be consistent with that of the connected third-party device.
NOTE:
•
This function is not supported by some models, please see the actual model for details.
•
The actual displayed Web interface may vary with the device model.
PTZ control
To control a PTZ camera through a third-party device, you
need to set Port Mode to PTZ Control.
By sending PELCO-D compliant PTZ control commands
through the RS485 port, you can control the PTZ camera
without using the PTZ control panel.
1. Click Setup > System > Ports & Devices, and then click the
Serial Port tab.
2. Select PTZ Control from the Port Mode drop-down list. The
following table describes some major parameters.
a. PTZ Protocol
i. Set the PTZ protocol that the channel
supports.
b. PTZ Mode
i. Built-in PTZ Priority: When this option is selected, the camera first tries to control the PTZ (for
example, to zoom or focus) by itself instead of through the external PTZ. For operations that the
camera cannot accomplish by itself, the camera uses the external PTZ.
1. You can set this parameter only
when Port Mode is set to PTZ
Control.
2. When PTZ Protocol is set to INTERNAL-PTZ, the camera can connect to the external PTZ
without using the serial port (serial port parameters are grayed out). In this case, you only
need to connect the zoom and focus interfaces of the camera to the lens, and then you can
operate the PTZ like an internal PTZ.
45