Table of Contents
Advertisement
Digital Projection E-Vision 6900 Series
Changing The Lens, Lamps, Filter And Color Wheel
Inserting a new lens
1.
Remove the front and rear lens caps.
2.
Position the lens so that the labels are at the top, and gently insert it
all the way into the lens mount.
3.
Push the lens in firmly and turn it clockwise until it clicks into place.
Removing the lens
1.
Push in the lens release lever, and turn the lens anti-clockwise.
2.
Remove the lens..
Installation and Quick-Start Guide
CHANGING THE LENS, LAMPS, FILTER AND COLOR WHEEL
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the lens, avoid
using excessive force as this may
damage the equipment.
The lens is shipped separately.
Take care to preserve the original
lens packaging and protective caps
for future use.
Rev A February 2017
page 11
Advertisement
Table of Contents
