Changing The Lens; Changing The Lens; The Lens Hood - Digital Projection HIGHlite Laser 3D Series Installation And Quick Start Manual

Digital Projection HIGHlite Laser 3D Series

Changing The Lens

The lens hood

There are two types of lens hood, short and long.
The short lens hood is used with the following lenses:
Throw ratios Part number
0.77 : 1 fixed lens 110-808
1.16 : 1 fixed lens 110-809
1.45 - 1.74 : 1 zoom lens 110-803
1.74 - 2.17 : 1 zoom lens 112-878
2.17 - 2.90 : 1 zoom lens 113-852
2.90 - 4.34 : 1 zoom lens 110-806
The long lens hood must be used with the following long throw lens:
Throw ratios Part number
4.34 - 6.76 : 1 zoom lens 110-807
Installation and Quick-Start Guide

CHANGING THE LENS

Projector with short lens hood fitted
Projector with long lens hood fitted
Notes
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the lens, avoid
using excessive force as this may
damage the equipment.
Take care to preserve the original
lens packaging and protective caps
for future use.
Do not use the short lens hood
with the long throw lens.
The projector will not power on
without the lens and lens hood fitted.
Rev C February 2015
page 13