Table of Contents
Advertisement
Digital Projection Ltd. Titan Laser WUXGA
Changing the lens
Inserting a new lens
1. Turn the lens release lever clockwise so that it is pointing upwards, to open the lock fully.
2. Remove the rear lens cap from the lens.
3. Insert the lens into the lens aperture, making sure that the plug on the zoom drive
mechanism lines up with the socket on the front of the projector, then push the lens in firmly
as far as it will go.
4. Turn the lens release lever anti-clockwise to the mid-position.
5. The lens can now be pushed in further. Push the lens in firmly as far as it will go.
6. Turn the lens release lever fully anti-clockwise so that it is pointing downwards, to close the
3
lock fully.
Removing the lens
To remove the lens, reverse the procedure described in Inserting a new lens above:
1. Turn the release lever up to the mid-position, then pull the lens out as far as it will go.
2. Turn the release lever clockwise so it is pointing upwards, then pull the lens out completely.
Rev A January 2019
page 26
Changing the lens
1
2
Before changing the
lens, always make sure
the projector is switched
off and fully
disconnected from its
power supply.
When changing the lens,
avoid using excessive
force as this may
damage the equipment.
1
The lens is shipped
separately.
Take care to preserve the
original lens packaging
and protective caps for
future use.
2
3
Installation & Quick Start Guide
Notes
Advertisement
Table of Contents
