Table of Contents
Advertisement
Disassembly Procedures
• To avoid risk of electrical shock, personal injury, or death; disconnect electrical and gas supply before servicing.
• To avoid risk of death; always test unit for gas leaks after repairs are completed.
Door Disassembly (solid door)
1. Remove oven door from range and place on a
protected surface.
2. Remove screws securing door panel to door backer.
3. Remove screws securing door handle and spacers to
door handle.
4. Carefully remove door gasket from the door, see
"Door Gasket (solid door)" procedures (steps 2–3).
5. Replace and reassemble in reverse order.
Door Gasket (solid door)
1. Open oven door completely.
2. Graspbottom corner of the gasket and push
downward releasing metal tab from the oven door.
3. Grasp the top corner of the gasket pulling upward at
an angle releasing metal tab from the oven door.
4. Replace and reassemble in reverse order.
Door Disassembly (frameless)
1. Open oven door and remove screws securing door to
hinges (if so equipped).
2. Open oven door to first stop position (1/3 open) then
grasp both sides and lift off the hinges. Place on a
protected surface.
3. Remove screws on right and left sides of oven door.
4. Remove screws from the bottom of oven door.
Detach right and left end caps and glass support
angles.
5. Remove side screws securing top door trim to oven
backer. Separate glass outer door, trim and handle
from door assembly.
6. Detach door handle by removing door handle
screws.
7. Detach heat shield from oven door backer, by
removing hex screws.
8. Access remainder of door assembly by removing hex
screws from oven door backer.
9. Reverse procedure to reassemble.
Oven Door Hinge
1. Turn off electrical power to range.
2. Remove oven door assembly from the range,
remove screws securing oven door to hinges if so
equipped.
3. Carefully open the hinge fully, and insert a wooden
dowel or screwdriver bit into opening marked A on
the following diagram.
4. Remove the top and bottom screws securing hinge
assembly to the front frame.
RS2310004 Rev. 1
!
WARNING
5. Slide the hinge assembly up and move top of hinge
towards rear of the range. Withdraw hinge assembly
through the frame opening.
6. Reverse procedure to reinstall oven door hinge
assembly.
Side Panel Removal
NOTE: Replace left or right side panel one at a time. Do
not attempt to remove both side panels as lack
of support may cause subsequent damage/twist
to backguard.
1. Turn off power to unit.
2. Disconnect electrical power and gas line from range.
3. Remove oven door assembly.
4. Remove storage drawer assembly.
5. Remove maintop.
6. Remove lower rear galvanized cover from appliance.
7. Support side of range four to six inches off floor.
Remove four screws from bottom flange of side
panel.
8. Remove main top support rod on side being
repaired, if applicable.
9. Remove screws securing side panel to rear
insulation retainer.
10.Remove screws securing backguard support to side
panel.
11. Remove screws securing drip baffle to side panel.
12.Remove screws securing side panel to front frame
flange.
13.Move rear of side panel away from range then move
side panel forward to clear flange.
14.Reverse procedure to reinstall side panel.
Power Cord
1. Turn off electrical power and gas to the range.
2. Disconnect gas line and power cord from unit.
3. Disconnect power cord plug located behind back
panel.
5. Remove screw securing cord to unit.
6. Replace and reassemble in reverse order.
50
Advertisement
Table of Contents
