Installation Instructions Sealed Burner
Converting for Use with Natural Gas or
Propane Gas
This range arrives from factory adjusted for use with
natural gas. If using LP/propane gas is desired, range
must be converted. See "Type 1" or "Type 2" regulator.
!
WARNING
To avoid electric shock that can cause personal injury
or death, disconnect main electrical supply to range
before servicing.
Converting Type 1 Pressure Regulator for Use with
LP/ Propane
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
• Insert must show "LPG10" or "LP10".
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of
regulator.
A
A—Cap
B—Plastic Insert (LP setting)
C—Spring Location
RS2310004 Rev. 1
Converting Type 2 Pressure Regulator for Use with
LP/Propane
1. Remove pressure regulator cap with a wrench.
2. Reverse pressure regulator cap.
3. Place pressure regulator cap on pressure regulator
Converting Surface Burners for Use with
LP\Propane
1. Remove 5 control knobs from range.
2. Remove 2 screws from burner control panel.
3. Grasp bottom of burner control panel, gently lift and
B
C
4. While facing range front, turn orifice hoods
22
• Cap must show "LP".
and tighten.
LP
A
A—Cap
• Exposes 2 screws on burner control panel.
• Panel drops slightly after screws are removed.
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside. See Pivot Point in figure.
• Gas valve and orifice hood are visible after burner
control panel is removed.
A
D
A—Burner Control Knob
B—Pivot Point
C—Burner Control Panel
D—Screw
counterclockwise 1½ to 2 turns or until snug.
• Use ½ inch open end or 90° offset open end
wrench.
B
C