Table of Contents
Advertisement
Installation Instructions Sealed Burner
Converting Surface Burners for Use with
Natural Gas
1. Remove 5 control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
• Gas valve and orifice hood are visible after burner
control panel are removed.
4. While facing range front, turn orifice hoods clockwise
1½ to 2 turns.
• Use ½ inch, 90° offset crescent wrench.
5. Close air shutter to approximately
Converting Oven Burner for Use with Natural Gas
1. Open broiler door and remove broiler rack, pan, and
grid.
2. Turn orifice hood counterclockwise (loosen) 2 full
turns.
3. Close air shutter to approximately
4. Replace broiler door.
Converting Oven Thermostat for Use with Natural
Gas
1. Remove 5 control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
4. Turn the selector screw so the pointer is towards "N".
5. Reverse steps 1-3 to replace control panel and
knobs.
RS2310004 Rev. 1
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1. Measure 3
2. Position anti-tip bracket.
3
/
inch.
8
3
/
inch.
8
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
5. Secure bracket to floor using screws supplied.
6. After range is slide into position, verify the range
24
1
/
inches from back wall on right and left
2
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
• If range is installed beside cabinet(s), place anti-
tip bracket with back edge on line drawn on floor
and side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
line drawn 3
1
/
inches from back wall and side of
2
bracket over line drawn along side of range on
floor.
• Anti-tip bracket can be installed on either right or
left side.
or
• If drilling into wood, use a
• If drilling into concrete, use a
drill bit and insert plastic anchors.
leveling leg has engaged anti-tip bracket.
3 1/2"
3
/
inch drill bit.
32
3
/
inch masonry
16
Advertisement
Table of Contents
