Bake And Broil Burners - Amana rs2310004-aro3100 Service

Troubleshooting Procedures
!

Bake and Broil Burners

Problem
Sooting from burner
flame.
Flame blows away from
burner.
Flames flash back into
mixer head.
Floating flame.
Gas smell.
Gas valve opens but
bake and broiler burners
do not ignite. Delayed
ignition.
Oven light does not
operate.
WARNING
Possible Cause
• Too little primary air.
• Burner head bent.
• If using LP gas, range may not be
properly converted.
• Too much air.
• Gas pressure too high.
• Draft around cooktop area.
• Too much air.
• Blocked flue or burner.
• Not enough air.
• Leak in pipe joints.
• Valve leak.
• Regulator plug loose.
• Bake/Broil ignitor positioned too far
from burner.
• Range is not properly converted for
LP gas.
• Low gas pressure.
• Misalignment of orifice and burner.
• Partial blockage of orifice, burner or
feed tube.
• Failed oven lamp.
• Failed light switch.
• Failed wiring.
• Failed light socket.
To avoid risk of electrical shock, personal injury or death,
disconnect power and gas supply before servicing,
unless testing requires it.
• Open air shutter on burner.
• Level burner head.
• Verify correct conversion procedures.
• Slightly close air shutter to burner.
• Verify correct gas pressure.
• Eliminate source of draft.
• Close air shutter slightly.
• Check for possible blockage in burner.
• Open air shutter.
• Verify gas connections and tighten if
necessary.
• Check valves and replace if necessary.
• Check and tighten regulator plug.
• Reposition Bake/Broil ignitor closer to
the burner.
• Verify correct conversion procedures.
• Verify correct gas pressure.
• Check alignment of burner and orifice
and align correctly.
• Check for blockage or burr in orifice.
• Check lamp and replace if necessary.
• Check switch contacts.
• Check for broken wires and loose or
dirty connections.
• Check light socket for continuity.
47
Correction
RS2310004 Rev. 1