Remove Shipping Screws; Place Rangetop And Grates; Ignite Oven Burner Pilot; Test And Adjust Oven Burner Flame - Amana rs2310004-aro3100 Service

Manual clean gas ranges
Table of Contents

Advertisement

Installation Instructions Open Burner

Remove Shipping Screws

Remove shipping screws.
Shipping Screws

Place Rangetop and Grates

Replace rangetop and place grates over burners. A peg
on each side of range holds rangetop in place.
RS2310004 Rev. 1

Ignite Oven Burner Pilot

1. Open broiler door and remove broiler pan, grid, and
rack.
2. In rear of broiler cavity, hold a match near pilot as
shown in illustration.
3. Quickly remove hand and match when pilot ignites.

Test and Adjust Oven Burner Flame

Turn on oven burner. See "Baking" section for oven
burner operating instructions. Properly adjusted oven
burner flames are blue with a distinct deep blue inner
cone approximately ½ inch long. When using natural
gas, flame should not have any yellow flame when
burning. Some yellow flame when burning LP\propane
gas is normal.
Flame should not be visible in the oven cavity when
burning and should not extend into the oven cavity
beyond the removable oven bottom.
• If burner flame is blowing or noisy, reduce airflow to
burner.
• If burner flame is yellow and does not hold its shape,
increase airflow to burner.
1. Check that oven temperature knob is in OFF position.
2. Open broiler door and remove broiler pan, grid, and
rack.
3. Through rectangular hole in rear of broiler cavity,
loosen air shutter lock screw and open or close air
shutter.
• Tighten air shutter lock screw after adjusting.
A
B
A—Air Shutter Lock Screw
B—Air Shutter
4. Repeat test if necessary.
5. Replace broiler pan, grid, and rack.
18
Open
Close

Advertisement

Table of Contents
loading

Table of Contents