Amana rs2310004-aro3100 Service page 23

Installation Instructions Sealed Burner
• Do not over tighten orifice hoods. If orifice hoods
are over tightened, gas supply can be cutoff or
orifice hoods can strip.
5. Open air shutter fully.
A
B
A—Orifice Hood
B—Air Shutter
Converting Oven Thermostat for Use with
LP\Propane
1. Remove all (5) control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
4. Turn the selector screw on oven thermostat so the
pointer is towards "LP".
5. Reverse steps 1–3 to replace control panel and
knobs.
Selector Screw
Open Fully
LP N N
LP
OFF OFF
LP N
OFF
23
Converting Oven Burner for Use with LP\Propane
1. Open broiler door and remove broiler rack, pan, and
grid.
2. Through rectangular hole on rear of broiler cavity,
turn orifice hood (tighten), clockwise when facing
front of range, 1½ to 2 turns or until snug.
• Do not overtighten orifice hoods. Orifice hoods
can strip.
3. Loosen aur shutter lock screw and open air shutter
fully.
• Tighten air shutter lock screw after adjusting.
Open
Fully
A—Air Shutter Screw
B—Orifice Hood
C—Air Shutter
Converting Type 1 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap with a wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
• Insert must show "NAT" or be blank.
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of
regulator.
Converting Type 2 Pressure Regulator for Use with
Natural Gas
1. Remove pressure regulator cap with a wrench.
2. Reverse pressure regulator cap.
• Insert shows "NAT" or is blank.
3. Place pressure regulator cap on pressure regulator
and tighten.
C
A
B
RS2310004 Rev. 1