ACME MH-575S User Manual page 6

10-
DMX512 Address Setting
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press the ENTER button to setup or automatically
return to the main functions without any change after 8 seconds. To go back to the functions
without any change press the MENU button again.
Show Mode
Press the MENU button up to when the
ENTER button and the display will blink. Use DOWN and UP button to select the
(show 1) or (show 2) or
mode has been selected, press the ENTER button to setup or automatically return to the
main functions without any change after 8 seconds. To go back to the functions without any
change press the MENU button again.
Show 1 mode - Fixture is placed on the floor. Tilt movement angle 210°.
Show 2 mode - Fixture is fixed under ceiling. Tilt movement angle 90°.
Show 3 mode - Fixture is placed on the speaker, The spot is always projecting
to the audience's direction; i.e in front of the stage. Pan movement angle ( left to
right to left ): 160°. Tilt movement angle: 90° ( 60° above horizon; 30° below
horizon).
Show 4 mode - Fixture is fixed under ceiling. The spot is mainly projecting in
front of the stage. Pan movement angle (left to right to left) :160°.
movement angle: 90° ( vertically, front 75°; back 15° ) .
Slave Mode
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to select the
or (normal) or (2 light show) mode. Once the mode has been selected,
press the ENTER button to setup or automatically return to the main functions without any
change after 8 seconds. To go back to the functions without any change press the MENU
button again.
is shown on the display. Pressing ENTER
is showing on the display. Pressing
(show 3) or (show 4) mode. Once the
is shown on the display. Pressing ENTER
11-
Tilt
(Master)