Table of Contents
Advertisement
4. When burning, the lamp operates at high pressure and there is a slight risk of arc tube
rupture. The risk increases with age, temperature and improper handling of the lamp. Do
not use the lamp any longer than its specified life.
5. Make sure the lamp is located in the center of the reflector for the best spot.
4. How To Set The Unit
4.1. Control Panel
Display
To show the various menus and the selected functions
LED
DMX
On
MASTER
On
SLAVE
On
SOUND
Flashing
Button
MENU
To select the programming functions
DOWN
To go backward in the selected functions
UP
To go forward in the selected functions
ENTER
To confirm the selected functions
DMX input/output
For DMX512 operation, use 3-pin XLR plug cable to link the unit together.
DMX input present
Master mode
Slave mode
Sound activation
8-
Power Switch
Switch power ON/OFF
Power Input
Connect to supply power for the fixture.
4.2. Main Function
To select any of the pre-set functions, press the MENU button up to when the required one
is shown on the display. Select the function by ENTER button and the display will blink. Use
DOWN and UP button to change the mode. Once the required mode has been selected,
press the ENTER button to setup or it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press the
MENU button. The main functions are shown below:
9-
Hide quick links:
Advertisement
Table of Contents
