Led Lighting; Switch Installation - Carefree TRAVEL'RFIXED PITCH Service Manual

T '
RAVEL R
LED L
IGHTING
S I
WITCH NSTALLATION
NOTE: Installers may choose to furnish the control switch. The installation requires that the power line
(+12VDC) be attached to a dedicated 2A circuit breaker or a 2A in-line fuse must be installed
between the switch and power source. For easy access, locate the fuse close to the switch.
1. Determine the location of the switch.
2. At the switch location, cut a 1 1/8" x 1 1/2" hole.
3. Wire the switch as shown below.
Wire terminals at the switch are .187,
18-24 awg female disconnects.
NOTE: Allow adequate slack in the
12VDC power line so that the
in-line fuse (installed in step 4)
can be accessed from behind
the switch.
4. Install the in-line fuse:
4.1. Near the switch, cut the red
12VDC power line to the switch.
Do not strip the insulation.
4.2. Insert a wire end into one of the
wire channels until it butts up
against the stop.
4.3. Fold that half of the connector
body over until the element
contacts the wire. Use pliers to
crimp the connector closed.
4.4. Repeat for the second wire end.
4.5. Slide the fuse into the fuse port.
Ensure that is firmly seated.
5. Press the in-line fuse, wires and
switch into the mounting hole. Secure
the switch using two (2) #6 x 1/2"
screws.
6. Snap the switch bezel over the switch
frame.
16
Service Manual
#6 x 1/2" Screw (x2)
O N
2 . 9 "
O F F
1 . 8 8 "
+12VDC
2A
In-line Fuse
Red
18awg Wire
(minimum)
Single Throw Switch
Vehicle Wall
LED Strip in Roller Tube
Carefree of Colorado
1 . 1 3 "
2A In-line Fuse
(+12VDC Line)
1 . 5 "
18-24awg
Female Disconnect (x2)
Single Pole
Connector in
Roller Tube
052540-301r10
GND
Wire Sewn in
Canopy Hem
LED002b