Factory Installed Leds (Optional); White Led Schematic And Layout; Harness Routing Into The Vehicle - Carefree FIESTA Installation Manual

M P A
ANUAL ATIO WNING
F I
ACTORY NSTALLED
S
PECIFICATIONS
Mounting a) LED light strip is mounted in the roller tube. The power harness is concealed in the canopy hem.
Options:
LED light strip is mounted at the awning rail. Requires special canopy with integrated strip holder.
b)
Length: Available for awnings 10' – 21'
Power: 1A, 12Vdc
Color: Bright White
Control: Single pole, single throw switch (SR0101)
Note: For an installer furnished switch, see notes in "Switch Installation" on page 7
NOTICE
The following information must be followed to avoid damage to the wiring during and
after installation.
a) The wire should be secured to the wall of the vehicle where it is exposed on the outside of the vehicle.
Use a quality silicone sealant/adhesive.
b) Do not route the wire over sharp edges or heat sources that can damage the wires or wire insulation.
c) Damage that is a result of improper routing may void warranty.
W LED S
HITE CHEMATIC AND
+12VDC
Red
18awg Wire
Single Throw Switch
(minimum)
Vehicle Wall
LED Strip
H R
ARNESS OUTING INTO THE
1. Drill a 3/16" hole into the vehicle wall below the right edge of the canopy.
2. Route the wires from the canopy into the vehicle. Allow slack in the wire between the canopy and the
wall. Seal the hole and wires with a quality silicone sealant.
3. Attach excess wires and connectors (for awning rail applications) along the bottom of the awning rail
using a quality silicone sealant.
NOTE: There is approximately 8 feet of wire from the wall entry point. Controls should be located
within this distance.
6
LED
S
6000K (standard)
L
AYOUT
2A In-line Fuse
18-24awg
Female Disconnect (x2)
Single Pole
Power Harness
V
EHICLE
Installation Manual
(O )
PTIONAL
GND
Route Wire With Slack
Between Canopy and Wall
Canopy Harness
Power Harness
Sewn in Canopy Hem
Roller Tube Mount
3/16" Hole
Attach Wires Along
Bottom of Awning Rail
Awning Rail LED
Carefree of Colorado
LED Strip
in LED Slot
LED Holder
at Awning Rail
3/16" Hole
LED002a
052876-005r3