Carefree TRAVEL'RFIXED PITCH Service Manual page 14

Carefree of Colorado
D02 ( )
CONT
E Test Switch Function – Single Switch Installation (this test requires a continuity tester)
The Patio Switch used in the Single Switch Installation is a center on that is internally cross-wired to short in the
center position to provide dynamic braking for the motor to prevent "drift" when the awning is stopped.
Test 1 is for Series I & II switches. Use Test 2 for Series III switches.
Observe continuity for switch in center position, extend position and retract position.
1a Place one lead of tester
on pin 2B. Touch 2nd
lead to the other pins
one at a time.
1b Place one lead of tester
on pin 5B. Touch 2nd
lead to the other pins
one at a time.
(Retract)
6 3
5B 2B
(Center)
4 1
(Extend)
Series I Switch
Test 2 is for Series III switches. Use Test 1 for Series I & II switches.
Observe continuity for switch in center position, extend position and retract position.
2a Place one lead of tester
on 12V pin (3). Touch
2nd lead to the other
pins one at a time.
2b Place one lead of tester
on Ground pin (1).
1
Touch 2nd lead to the
other pins one at a time.
2c Place one lead of tester
on Ground pin (5).
2
Touch 2nd lead to the
other pins one at a time.
Ground (1)
1
Retract (2)
12V (3)
Series III Switch
052540-301r10
Service Manual
Pin: Center Extend Retract
3 N Y
6 Y N
5B Y N
N = no continuity, Y = continuity
Pin: Center Extend Retract
3 N N
6 Y Y
N = no continuity, Y = continuity
(6) (3)
(5B) (2B)
Series II Switch
Pin: Center Extend Retract
2 N N
4 N Y
N = no continuity, Y = continuity
All other pins should be NO in all
switch positions
Pin: Center Extend Retract
2 Y Y
N = no continuity, Y = continuity
All other pins should be NO in all
switch positions
Pin: Center Extend Retract
4 Y N
N = no continuity, Y = continuity
All other pins should be NO in all
switch positions
(Retract)
Note:
The Series III switch terminals are not labeled.
(4) Extend
(Center)
The illustration is labeled for identification purposes
(5) Ground
2 in the procedures above.
(Extend)
YES Test OK, all checks pass – go to step
1b
N
Y
N NO Test failed; switch defective - replace
YES Test OK, all checks pass – Revaluate
problem, cause is not electrical
Y
N
NO Test failed; switch defective - replace
(Retract)
Note:
The Series II switch terminals are not labeled.
(Center)
The illustrations are labeled for identification purposes
in the procedures above.
(Extend)
YES Test OK, all checks pass – go to step 2b
Y
N
NO Test failed; switch defective - replace
YES Test OK, all checks pass – go to step 2c
N
NO Test failed; switch defective - replace
YES Test OK, all checks pass – Revaluate
problem, cause is not electrical
Y
NO Test failed; switch defective - replace
T '
RAVEL R
Travelr019
Travelr019a
11