Attaching The Fascia; Optional Led's; Wire Routing - Carefree Travel series Installation Manual

A T '
DJUSTABLE RAVEL R WITH
A F
TTACHING THE
The fascia fits inside the rear channel.
1. Open the awning to provide access to the bottom of the rear
channel.
2. Press the bottom dimples on the fascia into the rear channel until
they snap into the bottom holes in the sides of the rear channel.
3. Press the top of the fascia into the rear channel until the upper
dimples snap into the upper holes.
O LED'
PTIONAL
Optional White LED light strips mounted in the roller tube are available for aftermarket and OEM
installations. Some OEM's may offer LEDs at the awning rail.
NOTICES:
a. Do not route the wire over sharp edges or heat sources that can cut or fray the wires or wire
insulation.
b. Damage that is a result of improper routing
may void warranty.
W R
IRE OUTING
1. For roller tube LED's:
1.1 Route the LED canopy harness wires into the
vehicle with the awning motor wires as shown.
1.2 Allow a minimum 3" loop between the canopy and
rear channel
1.3 Secure the LED harness inside the channel with a
quality silicone sealant.
2. For optional OEM awning rail LED's:
2.1 Route the LED power harness into the vehicle
with the awning motor wires.
extend past the top of the channel.
2.2 For white LED's: On the outside of the vehicle
connect the power cord to the LED strip.
12
DR Installation Manual
ASCIA
S
Allow 3" - 4" to
Fascia
Attach Wires Along
Bottom of Awning Rail
Route Wires into
Vehicle with
Motor Wires
Canopy Harness
Allow 3"-4" of Harness
to Extend Past Top of Arm
Attach Wires Along
Bottom of Awning Rail
Route Wires into
Vehicle with
Motor Wires
Awning Rail LED
Carefree of Colorado
Rear Channel
Holes in Rear
Channel
Dimples
TravelR032c
Power Harness
Secure Inside Channel
with a Quality
Silcone Sealant
Motor Cable
Power Harness
Secure Inside Channel
with a Quality
Silcone Sealant
Motor Cable
LED001a
052540-031r4