Carefree TRAVEL'RFIXED PITCH Service Manual page 44

Carefree of Colorado
P
ROGRAMMING THE
When adding or replacing a remote control, it is necessary to program the
transmitter and receiver.
Stop
1. Power to the control box must be on.
2. Press and release the "Press to Learn Transmitter" button on the bottom of the
receiver box. The receiver is in program mode when the red light comes on.
3. Press and release the
after the receiver learns the remote signal.
NOTE: Pressing the stop button will cause the blue up arrow button to
default as the close (retract) function.
If a function button is pressed to train the receiver, it will be programmed as
the retract button. Example: Pressing the top button will program the top
button for retract and the bottom button as extend.
O
PERATIONAL
 Transmitter and receiver operate on frequency 433 MHz.
 The receiver exits the program mode after ten seconds.
 If the light does not come on, the memory is full and must be cleared.
 To clear the memory:
button, the indicator light should be OFF for the full 5 seconds then come on.
 If the light does not go out during programming, the receiver already knows the
transmitter's signal or the battery in the remote needs to be replaced.
 The system may be programmed for up to 5 remotes. Additional remotes may be
ordered separately.
R
EMOTE
Indicator
button on the remote. The red light will go out
STOP
N :
OTES
PRESS AND HOLD
R
ECEIVER
RR
Light
the transmitter learn button. While holding the
UP
Program
Button
DR020