Carefree TRAVEL'RFIXED PITCH Service Manual page 16

Carefree of Colorado
D04 D R
IRECT ESPONSE
The auto - retract system is only active when the power switch is in the ON position.
A Confirm awning operates normally using the standard
extend/retract switch with power on.
D05 D R
IRECT ESPONSE
Check Installation Integrity
A
Use the wiring diagram and confirm that the components and
wiring are properly installed and connected
Confirm Power Supply
B
Is vehicle battery or power source providing 10V to 14V to the
Power Switch?
C Test Motor Function
1. Remove the front cover of the motor head.
2. Disconnect the red and black wires from the module to the
terminals inside the rear cover.
3. Attach jumper leads to the emergency terminals located
on the back of the motor head.
4. Connect the other ends of the jumpers to a 12-18VDC
power source (i.e. drill battery). It may be necessary to try
then reverse the leads on the battery and try again.
5. Does the motor run?
Test Power Switch
D
1. Disconnect wires from Power Switch.
2. Using a continuity tester place one lead on each terminal.
3. With the switch in the OFF position, circuit should be
open.
4. With the switch in the ON position, circuit should be
closed.
Test the Extend/Retract Switch
E
1. Using a continuity tester, place one lead on center pin. Place
the second lead on bottom pin. Put the switch in the center
position and measure the continuity. Circuit should be open.
2. Press the switch down (Extend). Circuit should be open.
3. Press the switch up (Retract). Circuit should be closed.
4. Move the second lead to the top pin. Put the switch in the
center position and measure. Circuit should be open.
5. Press the switch down (Extend). Circuit should be closed.
6. Press the switch up (Retract). Circuit should be open
F Test wire continuity between motor and wire ends.
052540-301r10
Service Manual
A D N A
WNING OES OT UTO
S O
TANDARD PERATION
-R D W
ETRACT URING INDY
YES
Module is defective - replace
Go to Test D05
NO
YES Go to test B
Correct as required
NO
YES Go to test C
NO Correct as required
YES
Motor is good, go to test D
NO Motor is defective - replace
YES Switch is good, go to test E
Switch defective - replace switch
NO
assy.
YES Switch is good, go to test F
Switch defective - replace switch
NO
assy.
YES Wire continuity good – module is
defective replace
NO Repair as required then reconnect
the wires.
T
C
ONDITIONS
'
RAVEL R
13