Optional Led Lights; Switch Installation - Carefree MARQUEE Installation Manual

M
ARQUEE
O LED L
PTIONAL
Optional LED lighting is mounted in the lead rail. The wiring is routed along the top of the arm.
Route the LED wire harness with the motor cable into the vehicle.
NOTICE
The following information must be followed to avoid damage to the wiring during and
after installation.
a) The wire should be secured to the wall of the vehicle where it is exposed on the outside of the
vehicle. Use a quality silicone sealant/adhesive.
b) Do not route the wire over sharp edges or heat sources that can damage the wires or wire
insulation.
c) Damage that is a result of improper routing may void warranty.
S I
WITCH NSTALLATION
NOTE: Installers may choose to furnish the control switch. The installation requires that the power line
(+12VDC) be attached to a dedicated 2A circuit breaker or a 2A in-line fuse must be installed between the
switch and power source. For easy access, locate the fuse close to the switch.
#6 x 1/2" Screw (x2)
O N
O F F
+12VDC
2A In-line Fuse
Red
18awg Wire
(minimum)
Single Pole, Single Throw Switch
1. Determine the location of the switch.
2. At the switch location, cut a 1 1/8" x 1 1/2" hole.
3. Wire the switch as shown below. Wire terminals at the switch are .187, 18-24 awg female disconnects.
NOTE: Allow adequate slack in the 12VDC power line so that the in-line fuse (installed in step 4) can be
accessed from behind the switch.
4. Install the in-line fuse:
4.1. Near the switch, cut the red 12VDC power line to the switch. Do not strip the insulation.
4.2. Insert a wire end into one of the wire channels until it butts up against the stop.
4.3. Fold that half of the connector body over until the element contacts the wire. Use pliers to crimp
the connector closed.
4.4. Repeat for the second wire end.
4.5. Slide the fuse into the fuse port. Ensure that the fuse is firmly seated.
5. Press the in-line fuse, wires and switch into the mounting hole. Secure the switch using two (2) #6 x
1/2" screws.
6. Snap the switch bezel over the switch frame.
8
Installation Manual
IGHTS
1 . 1 3 "
1 . 5 "
2A In-line Fuse
(+12VDC Line)
18-24awg
Female Disconnect (x2)
Red (from power harness)
+12VDC
2A In-line Fuse
Red
18awg Wire
(minimum)
Vehicle Wall
LED Strip
18-24awg
Female Disconnect (x2)
+12VDC
2A In-line Fuse
Red
18awg Wire
(minimum)
Lighted Single Throw Switch
Carefree of Colorado
See Switch Detail
Switch
GND
GND
Red (from power harness)
LED020
052549-001r8