Carefree TRAVEL'RFIXED PITCH Service Manual page 6

Carefree of Colorado
21. Check that the fabric is properly positioned. Adjust as required.
21.1. For vinyl canopies: Center the fabric on the roller tube. install the fabric retaining screws removed
previously.
21.2. For acrylic canopies: The canopy is flared (tapered) only on the motor side. The canopy is
centered in the roller tube. The LH (idler) edge of the canopy should be parallel to the centerline of the
idler arm leaving a larger space between the roller end cap and fabric on the motor side. Install the
fabric retaining screws removed previously.
Awning Rail
Weatherguard or FLXguard
Roller Tube
2.5"
Awning Rail
Alumaguard/Uniguard
.5"
Alumaguard
1.5"
Uniguard
Roller Tube
3"
4"
22. Roll the awning in and out several times to make sure that the fabric rolls squarely on the roller tube.
23. Secure the canopy to the awning rail using one, #6 x 3/8" hex head screw at both sides of the awning.
1"
Awning Rail
Fabric
23.1. For vinyl awnings, place screw through awning rail, polyrod and canopy approximately 1" in from
the end of the fabric.
23.2. For Uniguard awnings, place screw through awning rail, polyrod and the soft connect material
approximately 1" in from the end of the fabric.
23.3. For Alumaguard awnings, place screw on the outer edge of the Alumaguard (not through the
Alumaguard).
052540-301r10
Service Manual
Vinyl w/
Canopy
Valance
2.5"
Vinyl w/
Canopy
Valance
Alumaguard
Uniguard
Dimensions are approximate.
Polyrod Awning Rail
Soft Connect
#6 x 3/8
Screw
Uniguard
Fabric
Awning Rail
Roller Tube
Awning Rail
.5"
Alumaguard
1.5"
Uniguard
Roller Tube
3"
4"
1"
Polyrod
#6 x 3/8
Screw
Acrylic w/
FLXguard
LH Canopy Edge Parallel
w/ Centerline of Arm
Canopy
Valance
Acrylic w/
Alumaguard/Uniguard
LH Canopy Edge Parallel
w/ Centerline of Arm
Canopy
Valance
Alumaguard
Uniguard
Awning Rail
#6 x 3/8
Screw
Alumaguard
T '
RAVEL R
NOT
1.5"
2"
3"
CA006a
E0014
3