Replacing The Led Strip - Carefree TRAVEL'RFIXED PITCH Service Manual

Carefree of Colorado
R LED S
EPLACING THE
1. Extend the awning out completely.
2. Disconnect power.
3. Use a non-permanent marker to mark the location
of the ends of the LED strip.
4. Clamp the canopy harness in the canopy to prevent
the wire from pulling up into the seam of the canopy.
This can be done with a paper clip or similar device
that will not damage the wires or canopy.
5. Remove the slot covers from the ends of the LED
strip and set aside.
6. Carefully pull the wires and connectors out of the
roller tube through the hole that is located behind
the slot cover
connectors.
7. Remove the existing LED strip.
8. Clean the slot to remove any dirt and tape residue.
9. Starting at the reference mark made previously, remove the release paper from the back of the new strip and
press the strip into the LED slot.
10. At the end of the roller tube, cut the LED strip to match the mark made previously. To trim the LED
strip, always cut between the 4-pad cluster as shown.
11. Connect the canopy harness connector and LED connector. Then carefully push the connectors into
the roller tube.
12. Press the slot covers into the LED slot.
13. Restore power and test.
052540-301r10
Service Manual
TRIP
location. Disconnect
Clamp the Canopy
Harness in this locaion
Canopy Harness
the
Cut Between Pads
to Adjust Length
T '
RAVEL R
LED Slot
LED Strip
Slot Cover
LED005a
17