Attaching The Harness To Fabric Wrap - Carefree TRAVEL'RFIXED PITCH Service Manual

Carefree of Colorado
A H
TTACHING THE
When replacing the canopy only or replacing the canopy harness, it is necessary to attach the cable to the
inside of the wrap.
For vinyl canopies with Weatherguard, the harness is routed in the seam of the Weatherguard, no
additional attachment is necessary.
For other wraps follow the directions below:
1. Open the awning to access the inside surface of the wrap.
2. Clean the inside surface of the wrap.
1" x 2" Velcro "Loop"
ALUMAGUARD
3. Attach the harness to the inside surface.
3.1. For Alumaguard: Use 1" by 2" pieces of Velcro (loop) taping the harness on each slat between the
joints.
3.2. For Uniguard: Tape the harness to the inside surface using a 2" x 8" piece of Velcro (loop).
3.3. For FLXguard: Position the harness approximately 3/8" from the edge of the material. Attach
using a 1" x 6" piece of clear tape (the tape is a special bond tape available from Carefree).
052540-301r10
Service Manual
F
ARNESS TO ABRIC
2" x 8" Velcro "Loop"
UNIGUARD
W
RAP
3/8" From Edge
1" x 6" Clear Tape
Position Wire
FLXguard
T '
RAVEL R
LED008
19