Appendix; Additional Documents - ABB FSM4000 Operating Instruction

Appendix

Pos: 54 /Überschriften/1/A - C/Anhang @ 0\mod_1132904773022_3101.doc @ 3134
13 Appendix
Pos: 55 /Überschriften/1.1/1-spaltig/V - Z/Weitere Dokumente @ 0\mod_1134369962894_3101.doc @ 3218

13.1 Additional documents

Pos: 56 /Anhang/Durchfluss/FSM4000/Weitere Dokumente (BA) @ 16\mod_1197302417718_3101.doc @ 145545
• Data sheet (D184S073Uxx)
• Interface description for devices with HART communication (D184B126U01/02)
• Interface description for devices with PROFIBUS PA communication (D184B093U29/30)
• Interface description for devices with PROFIBUS Fieldbus communication
(D184B093U31/32)
Pos: 57 /Überschriften/1.1/1-spaltig/V - Z/Zulassungen und Zertifizierungen @ 0\mod_1132230068395_3101.doc @ 3806
13.2 Permits and certifications
Pos: 58 /Anhang/Durchfluss/FXE4000/Zertifizierungen (Standard-Ausführung) @ 1\mod_1144235212890_3101.doc @ 5690
Symbol
CE mark
Pos: 59 /==== Leeres Modul mit einer Absatzmarke, DS, 1-spaltig ==== @ 2\mod_1153381574375_0.doc @ 35553
Pos: 60 /Hinweise/Wichtig/Wichtig - Verweis auf Download-Bereich @ 21\mod_1215086830219_3101.doc @ 204693
Important
All documentation, declarations of conformity and certificates are available in the download
area of ABB.
www.abb.com/flow
Pos: 61 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
118
Description
The CE mark indicates that the device complies with the following directives and
their basic safety requirements:
CE mark on the name plate of transmitter
•
− Conforms with EMC directive 89/336/EWG
− Conforms with low voltage directive 73/23/EWG
CE mark on the factory tag of flowmeter sensor
•
−
Conforms with pressure equipment directive (PED) 97/23/EC
By placing the CE mark on its devices, ABB Automation Products GmbH declares
its conformance with these directives.
Pressure equipment does not receive a CE mark on the factory tag, if the
following conditions exist:
The max. permissible pressure (PS) is less than 0.5 bar.
•
Due to low pressure risks (nominal width ≤ DN 25 / 1") no approval procedures
•
are required.
This unit was designed and manufactured in accordance with "sound engineering
practices".
FSM4000 D184B140U02