ABB FSM4000 Operating Instruction page 93

When displaying the operating hours / log time, the ID code combines data record and type
without underscore.
Data record
CVC: Current transmitter operating hours counter
P1C: Product1-Fingerprint transmitter log time
P2C: Product2-Fingerprint transmitter log time
DFC: Startup-Fingerprint transmitter log time
FVC: Factory Fingerprint transmitter log time
H1C – H9C: History 1 – 9 transmitter log time
CVP: Current flowmeter sensor operating hours counter
P1P: Product1-Fingerprint flowmeter sensor log time
P2P: Product2-Fingerprint flowmeter sensor log time
DFP: Startup-Fingerprint flowmeter sensor log time
FVP: Factory Fingerprint flowmeter sensor log time
H1P – H9P: History 1 – 9 flowmeter sensor log time
7.4.2.2 Diagnostic warning and error messages
All values acquired during diagnostics or a wiring error can trigger warnings or error messages.
Warnings are displayed in the fourth line only. In the event of an error, the contact output may
as an option (setting "General Alarm" or "ext. Diag. Alarm") be set to alarm state (in addition to
the information displayed in the fourth line).
To activate this option, select in the submenu "Diagnostics / Alert Settings" whether the error or
warning is triggered in the event of over or undershooting the specified range. To check for
wiring errors, you can activate this function under "Diagnostics / Wiring Error".
For additional information, refer to the relevant error registers. These can be selected and
accessed in the Submenus Display or Status.
D184B140U02
Type
FSM4000
Parameterization
Numerical Unit
value
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
H:Min:Sec -
93