ABB FSM4000 Operating Instruction page 70

Parameterization
Submenu/parameter
1st line
Q [Prozent]
1st line
PA Adr + State
1st line
TB VolFlow Value
1st line
TB VolFlow Status
1st line
TBT → Value
1st line
TBT → Status
1st line
FB AI OUT
1st line
FB AI Status
70
Value range Comment
Display 1st line
Q [percent]; Q [unit];
Iout [mA]; Q [m/s]; Q
Notes regarding the values Fprt1 ... Fprt4 (assignment of
BargraphTotalizer;
values in the submenu Diagnostic / Fingerprint) as well as
Totalizer → V;
the diagnostic error register, see chapter "7.4 Additional
Totalizer ← R;
information regarding use of enhanced diagnostic
Totalizer Diff.; HART
functions".
TAG Empty pipe
Blank
Add. choice at
enhanced diagnostic
functions:
Fprt1; Fprt2; Fprt3;
Fprt4; Hist Max Err;
Hist Min Err;
Act Max Err;
Ac Min Err;
Act Max Warn;
Act Min Warn;
Connect Warn;
Connect Err
For devices with PROFIBUS PA, the following options are
available: Flowrate in percentage, engineering unit, in
m/s, Bar graph, Totalizer, Totalizer→ F, Totalizer ← R,
Totalizer diff., Detector empty pipe; additional options:
PA Addr+State. The bus address and status of cyclic
communication is displayed (STOP, CLEAR or
OPERATE).
TB VolFlow Value. Displays the value for Volume_Flow
(Transducer block Index 17).
TB VolFlow Status. Displays the status of Volume_Flow
(Transducer block Index 17).
TB Total → F Value. Displays the value for Totalizer → F
(Transducer block Index 102).
TB Total → Status. Displays the status of the Totalizer
→ F (Transducer block Index 102).
TB Total ← R Value. Displays the value for Totalizer ←
R (Transducer block Index 104).
TB Total ← R Status. Displays the status of Totalizer ←
R (Transducer block Index 104).
TB Total Diff Value. Displays the value for the diff.
totalizer (Transducer block Index 106).
TB Total Diff Status. Displays the status of the diff.
totalizer (Transducer block Index 106).
FB AI OUT. Displays the OUT value of the AI block. The
decimal places are generated from the OUT_SCALE
structure. The unit displayed is UNIT_INDEX from the
OUT_SCALE structure.
FB AI Status. Displays the current mode of the particular
block and the status of the output variables (OUT.
Status). The substatus is displayed after the status, if
applicable. Example: BAD 3 means status is BAD,
substatus 3 = device failure.
For information about the numeric code, refer to the
interface documentation.
FSM4000 D184B140U02