Raised Overlay Panel Design - Monogram ZIS360N Installation Instructions Manual

Design Guide
DISPENSER MODELS:
RAISED OVERLAY PANEL DESIGN
When a raised panel design is to be used, a
custom wide middle rail is required to accept
the dispenser trim.
¢ The middle rail must be wide enough to allow
for the dispenser trim to overlap the opening.
¢ The middle rail must be 1.100" total thickness
to accept the dispenser trim.
1/4" Backer Panel
10" Spacer
3/4" Overlay Panel
:
Wide
Middle
Rail is
Required
DISPENSER TRIM FIT EXAMPLES:
(NOT TO SCALE)
1/4" FRAMED PANEL
¢ The dispenser trim fits over the
custom panel and snaps into the
freezer door.
¢ The clips will not engage the door if
the panel is more than 0.250" thick.
¢ If the panel is less than 0.250" thick, a
noticeable gap may be created
—§h
Kerem eMtclm RI eLliesiclg je
FREEZER DOOR
0.250"
1/4' Dispenser Trim
around the dispenser trim.
¢ The dispenser trim fits over the
custom panel and snaps into the
freezer door.
¢ The clips will not engage the door if
the panel is more than 1.100" thick. 3/4" Overlay
¢ If the panel is less than 1.100" thick, a Pane]
noticeable gap may be created
around the dispenser trim.
| .10" Spacer
Panel
rt
FREEZER DOOR
1.100"
Kerem eMtclm RI eLliesiclg
3/4" Overlay Dispenser Trim
Total Thickness