Displaying And Maintaining Ethernet Link Aggregation - HPE FlexFabric 5940 Series Configuration Manual

Figure 12 Link aggregation scenario before management subnets are used
You can configure a maximum of 20 management subnets.
To ensure correct packet forwarding, delete all ARP entries of a subnet before you specify it as a
management subnet or after you remove it from the management subnet list.
If you are using link aggregation management subnets, do not use ARP snooping. For more
information, see Layer 3—IP Services Configuration Guide.
To exclude a subnet from load sharing on aggregate links:
Step
Enter system view.
1.
Specify a link aggregation
2.
management subnet
Displaying and maintaining Ethernet link
aggregation
Execute display commands in any view and reset commands in user view.
Task
Display information for an aggregate interface
or multiple aggregate interfaces.
Display the local system ID.
Display the global or group-specific
link-aggregation load sharing modes.
Command
system-view
link-aggregation
management-subnet ip-address
{ mask | mask-length }
Command
display interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ] [ brief
[ description | down ] ]
display lacp system-id
display link-aggregation load-sharing mode [ interface
[ { bridge-aggregation | route-aggregation }
interface-number ] ]
63
Remarks
N/A
By default, no link aggregation
management subnets are
specified.