DFI DT122-SD User Manual page 41

InsydeH20 Setup Utility
Advanced
Fan Speed Count 1 [30]
Fan Speed Count 2 [40]
Fan Speed Count 3 [50]
Fan Speed Count 4 [75]
COM Port 1 <Enable>
Base I/O Address <3F8>
Interrupt <IRQ3>
COM Port 2 <Enable>
Base I/O Address <2F8>
Interrupt <IRQ4>
Type <RS232>
COM Port 3 <Enable>
Base I/O Address <3E8>
Interrupt <IRQ3>
COM Port 4 <Enable>
Base I/O Address <2E8>
Interrupt <IRQ4>
WDT <Disable>
Case Open <Disable>
AC Power Loss <Always off>
PC Health Status

F1 Help ↑/↓ Select Item F5/F6 Change Values
Esc Exit ←/→ Select Item Enter Select
Serial Port 1 to Serial Port 4
Configures the settings of the serial port.
Disable Disable this serial port.
Enable Enable this serial port.
Type
Choose RS232/RS422/RS485 for the serial port type for COM port 2 only.
Chapter 7 BIOS Setup
Rev. 5.0
Configure Serial port using
options: [Disable] No Con-
figuration [Enable] User
Configuration [Auto] EFI/
OS chooses configuration
F9 Setup Defaults
SubMenu F10 Save and Exit

Chapter 7
Advanced
Fan Speed Count 1
Fan Speed Count 2
Fan Speed Count 3
Fan Speed Count 4
COM Port 1
Base I/O Address
Interrupt
COM Port 2
Base I/O Address
Interrupt
Type
COM Port 3
Base I/O Address
Interrupt
COM Port 4
Base I/O Address
Interrupt
WDT
Case Open
AC Power Loss
PC Health Status

F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
WDT
Enable or disable the watchdog function.
Case Open
Enable or disable the case open function.
AC Power Loss
Set the AC power loss to Always off or Always on. When set to Always off, the system's status will
be power-off after an AC power loss event. When set to Always on, the system's status will be
power-on after an AC power loss event.
41
InsydeH20 Setup Utility Rev. 5.0
[30]
[40]
[50]
[75]
<Enable>
<3F8>
<IRQ3>
<Enable>
<2F8>
<IRQ4>
<RS232>
<Enable>
<3E8>
<IRQ3>
<Enable>
<2E8>
<IRQ4>
<Disable>
<Disable>
<Always off>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi.com