DFI DT122-SD User Manual page 38

Audio Configuration
This section configures the audio settings.
InsydeH20 Setup Utility
Advanced
HD Audio <Enabled>
F1 Help ↑/↓ Select Item F5/F6
Esc Exit ←/→ Select Item Enter
HD Audio
Control the detection of high-definition audio devices.
Disabled
HDA will be unconditionally disabled.
Enabled
HDA will be unconditionally enabled.
Auto
HDA will be enabled if present, disabled otherwise.
Chapter 7 BIOS Setup
Rev. 5.0
Control Detection of the
HD-Audio device.
Disabled = HDA will be
unconditionally disabled
Enabled = HDA will be
unconditionally enabled
Auto = HDA will be ena-
bled if present, disabled
otherwise.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 7
SATA Configuration
This section configures the SATA controller.
Advanced
SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Port 0
Serial ATA Port 1
Port 1
Serial ATA Port 2
Port 2
Serial ATA Port 3
Port 3
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
SATA Controller(s)
Enable or disable Serial ATA devices.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
RAID Mode (only with Intel
This option allows you to configure RAID on the Serial ATA devices .
Serial ATA Port 0, 1, 2, and 3
Enable or disable the serial ATA port.
38
InsydeH20 Setup Utility
Enable/Disable SATA
<Enabled>
Device.
<AHCI>
[ST4000NM0033-9ZM170 ]
<Enabled>
[Not Installed]
<Enabled>
[Not Installed]
<Enabled>
[Not Installed]
<Enabled>
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Q170 chipset)
®
Rev. 5.0
www.dfi.com