DFI DT122-SD User Manual page 40

ME Configuration
This section configures settings of flashing the Intel
InsydeH20 Setup Utility
Advanced
Me Fw Image Re-Flash <Disabled>
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
Me Fw Image Re-Flash
Enable or disable flashing of the Intel
Chapter 7 BIOS Setup
® Management Engine firmware.
Rev. 5.0
Enable/disable to flash ME
region
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

Management Engine firmware.
®
Chapter 7
SIO NUVOTON6106D
This section configures the system's super I/O chip parameters.
Advanced
SYS Smart Fan Control
Boundary 1
Boundary 2
Boundary 3
Boundary 4
Fan Speed Count 1
Fan Speed Count 2
Fan Speed Count 3
Fan Speed Count 4
CPU Smart Fan Control
Boundary 1
Boundary 2
Boundary 3
Boundary 4
Fan Speed Count 1
Fan Speed Count 2
Fan Speed Count 3
Fan Speed Count 4
SYS Smart Fan 2 Control
Boundary 1
Boundary 2
Boundary 3
Boundary 4
F1 Help ↑/↓ Select Item
Esc Exit ←/→ Select Item
SYS/CPU Smart Fan/Fan 2 Control
Enable or disable the system/CPU smart fan or fan 2.
Boundary 1 to Boundary 4
Set the boundary temperatures that determine the operation of the fan with differ-
ent fan speeds accordingly. For example, when the system or the CPU temperature
reaches boundary temperature 1, the system or CPU fan should be turned on and
operate at the designated speed.
The range of the temperature is from 0 to 127
Fan Speed Count 1 to Fan Speed Count 4
Set the fan speed. The range is from 0 (fan stop)-100% (full speed).
40
InsydeH20 Setup Utility Rev. 5.0
Enable/Disable Smart Fan
<Enable>
[30]
[40]
[50]
[60]
[30]
[40]
[50]
[75]
<Enable>
[30]
[40]
[50]
[60]
[30]
[40]
[50]
[75]
<Enable>
[30]
[40]
[50]
[60]
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

o C.
www.dfi.com