If The Ribbon Is Cut Off In The Middle - Toshiba BV410T-GS02-QM-S Owner's Manual

4.Troubleshooting
2 While pulling each of the right and left lock release portions [1] in the arrow direction, fully open
the top cover [2].
[ 1 ]
Remove the media jam.
3
Load the media correctly.
4
 P.37 "Loading the media"
5 Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
into place to make sure that it is closed securely.
Turn on the power to resume printing.
6

If the ribbon is cut off in the middle

If the ribbon is cut off in the middle, repair it with the procedure below. (Temporary measure)
If you have a new ribbon, replace the ribbon with that one.
 P.53 "Loading the ribbon (thermal transfer method)"
 Fully open the ribbon cover by bringing it backward.
Leaving it at a halfway position could cause it to close by itself, causing injury.
 Immediately after printing, do not touch the print head or its surrounding area.
This could cause burns.
Open the top cover [1] and the ribbon cover [2] and remove the cut off ribbon portions [3]
1
together with the ribbon spoolers.
[ 3 ]
[ 2 ]
[ 1 ]
[ 2 ]
[ 1 ]
Troubleshooting 77