Firmware Version 1.0.12.19 - Grandstream Networks UCM6200 Series User Manual

•
Added Email Send Log. [Email Send Log]
•
Added support for Mitel simulation/protocol interfaces for PMS module. [PMS]
•
Added support for up to 10 failover trunks. [Use Failover Trunk]

Firmware Version 1.0.12.19

•
Added support for binding a mobile phone number to extension. [Mobile Phone Number]
•
Added support OPUS codec.
•
Added support call-barging privilege settings based on extensions. [Monitor privilege control]
•
Added support for Seamless Transfer. [Seamless Transfer]
•
Added support for Custom Call-Info for Auto Answer. [Custom Call-info for Auto Answer]
•
Added support for DND Whitelist. [Do Not Disturb]
•
Add the Field Description on Softkey, Line keys and MPK from Zero Config.
•
Added support to select interval for numbers on Batch add extension. [Extension Incrementation]
•
Added support for Batch Add CallerID Number. [CallerID Number]
•
Added support for Search Extensions Using CallerID Name.
•
Added support to Enable/Disable Inbound and Outbound Route. [Disable This Route/Disable This Route]
•
Added support for Outbound Route Time Condition. [Time Condition]
•
Added support for IPv6. [IPv6 Address]
•
Added Support for MTU configurable. [MTU]
•
Added support of CRM. [CRM]
•
Added support for Custom Privilege in User Management. [Custom Privilege]
•
Added Hotline support for FXS Extension. [Hotline]
•
Added support for Separate Wakeup Service. [WAKEUP SERVICE]
•
Added ability to provision phones from different network subnets using zero config. [Subnet Whitelist]
•
One-key-dial is replaced by Speed Dial to support more than one digit. [SPEED DIAL]
•
Added Append extension number in the end of DOD. [Direct Outward Dialing (DOD)]
•
Support Japan CID NTT Detect.
•
Added support for Ethernet Capture Auto Sync to SFTP Server. [Enable SFTP Data Sync]
•
Added support for Ethernet Capture saved to External Storage Device. [Save to External Storage]
•
Added support for Disable Extension Range on the Setup Wizard. [Setup Wizard]
•
Added more support for Port Forwarding. [Port Forwarding]
•
Added support for USB/SD Card Files Cleanup. [USB Disk/SD Card File Management]
•
Added support for A Key Dial-up FXO. [key Dial-up FXO]
•
Added support for ACIM Detect Option for FXO. [INTERFACE SETTINGS]
•
Added support for some special character on the file name of FW. [Upgrading Via Local Upload]
•
Added more search criteria of CDR. [CDR]
•
Added support of "Allow outgoing calls if registration failure" for register trunks. [Allow outgoing calls if
registration failure]
•
Added support for music on hold playback from webGUI. [Music On Hold ]
•
Added support to enable delete recording files for user privilege. [Consumer]
•
Added support disk Inode usage in "Storage Usage" page. [Space Usage]
UCM6200 Series User Manual
Version 1.0.20.38
P a g e | 40