Preparing The Load - Miele G 7825 Operating Instructions Manual

Application technology
Preparing
the load
20
 Only items which have been declared by their manufacturer as
suitable for machine reprocessing may be reprocessed. The
manufacturer's specific reprocessing instructions must be
observed.
Disposable instruments must not be put into the machine for
reprocessing.
– Arrange the load so that water can access all surfaces. This
ensures that it gets properly cleaned.
– Do not place items to be cleaned inside other pieces where they
may be concealed.
– Hollow instruments must be thoroughly cleaned, internally and
externally.
– Ensure that instruments with long narrow hollow sections can be
flushed through properly before placing them in inserts or
connecting them to jets.
– Hollow items should be inverted and placed in the correct wash
cart, modules and inserts to ensure that water can flow in and out
of them unrestricted.
– Deep-sided items should be placed at an angle to make sure water
runs off them freely.
– Tall, narrow, hollow items should be placed in the centre of the
basket if possible to ensure better water coverage.
– Take apart any items which can be dismantled according to the
manufacturer's instructions and reprocess the individual parts
separately from each other.
– Lightweight items can be secured with cover nets (e.g. A 6), and
small parts can be placed in a small item mesh tray, so that they do
not block the spray arms or become attached to the magnetic strip
on the automatic program recognition.
– Only reprocess small items and micro components in special
inserts, mesh trays with lids or mesh inserts, such as e.g. E 473/1
for micro components.
– The spray arms must not be blocked by items that are too tall or
hang through the baskets. Gently rotate the arms by hand to check
mobility.
– It is advisable to use only instruments made of special application
steel which are not susceptible to corrosion.
– Items made of nickel and colour-anodised aluminum require special
reprocessing conditions and are not suitable for machine
reprocessing.
– Heat-sensitive load must only be reprocessed using a chemo-
thermal program.
– Plastic items must be thermally stable.