Electrical Connection - Miele G 7825 Operating Instructions Manual

 All electrical work must be carried out by a suitably qualified
electrician in accordance with local and national safety regulations.
– The electrical installation must be in compliance with current local
and national safety regulations.
– The plug connection must comply with national regulations, the
socket must be accessible after the machine has been installed.
This is to facilitate access for safety checks, for example when the
machine is being commissioned or serviced.
– For hard-wired machines, connection should be made via a suitable
mains switch with all-pole isolation. The contact opening between
all open contacts must be at least 3 mm wide and the mains switch
must be lockable in the open position.
– An equalization of the potentials should be carried out.
– For technical data, see the data plate or the attached wiring
diagram!
– For increased safety, it is recommended to protect the machine
with a 30 mA residual current device (RDC).
– The rotational direction of motorized power units depends on the
electrical connection of the washer-disinfector. Connect the
washer-disinfector in phase with clockwise rotating field.
Further notes on electrical connection are given on the Installation
diagram supplied with the machine.
The machine must only be operated with the voltage, frequency and
fuse rating shown on the data plate.
The data plate showing relevant test marks is located on the cover
plate behind the service panel on the unclean side of the machine.
The wiring diagram is supplied with the machine.
WARNING
THIS APPLIANCE MUST BE EARTHED

Electrical connection

59