en - Areas of application
Preparing the in-
sert
Pre-cleaning
breathing masks
Dismantling the
breathing mask
40
Preparing the load
Place the insert on the worktop and ensure that it is securely posi-
tioned.
Open the lids of the small parts baskets.
Check whether the breathing mask requires manual pre-cleaning,
e.g. to remove soot.
If required, carry this pre-cleaning out in line with the manufac-
turer's instructions.
Dismantle the breathing mask in line with the manufacturer's in-
structions.
Place the small parts in a small parts basket.
Place the inner mask in the small parts basket with the curved hol-
low side facing down.
Close the lid of the small parts basket.
Place the mask on top of the small parts basket.
Make sure that the small parts in the small parts basket and the
mask placed on top belong together.
Colour markings can be used if necessary. APLW 873, carabiner
hooks and hangers are available as optional accessories.