Acura 3.5 RL Manual page 1247

Power Windows
Descriptions
The driver's window will stop and automatically open if you pinch your hand or something during auto-up operation.
The system is composed of the power window master switch, the power window control unit and the driver's window
motor.
The power window motor incorporates a pulser which generates pulses during the motor's operation and sends the puls-
es to the power window control unit. As soon as the power window control unit detects no pulses from the pulser, the
control unit makes the power window motor stop and reverse.
POWER WINDOW MASTER
SWITCH
POWER WINDOW MOTOR
Sensor
MAGNET
Resetting the power window unit
Resetting the power window control unit is required after performing the following procedures:
— disconnecting the battery.
— removing No. 41 (20 A) fuse.
— disconnecting the connector from the power window control unit.
— removing the window regulator, glass or glass run channel.
1. Make sure the glass is installed properly.
2. Turn the ignition switch OFF.
3. Remove the No. 41 (20 A) fuse in the under-hood fuse/relay box.
4. Turn the ignition switch ON (II) on for 2 seconds, then turn it OFF. Reinstall the NO. 41 (20 A) fuse in the under-hood
fuse/relay box.
5. Turn the ignition switch ON (II).
6. Make sure the driver's window does not work in AUTO with the ignition switch ON (II).
7. Move the driver's window all the way down by using the driver's switch.
8. Move the driver's window all the way up by using the driver's switch when the window reaches the top, hold the
driver's window switch in the up position for 2 seconds.
* If the window does not work in AUTO, reset the power window master switch according to the above procedures again.
POWER WINDOW
CONTROL UNIT
Period of pulses
Period of pulses -
Period of
pulses
Threshold value for
judgment of pinching
HOLE IC UNIT
Position when something
is pinched
MAGNET