Dos Modules; Connecting Dos Modules; Dispensing Liquids; Neutralizing Agent - Miele PG 8583 Operating Instructions Manual

Connecting DOS
modules
Dispensing liquids For adjusting dispensing concentration, see "Further settings/
Adding and dispensing process chemicals

DOS modules

If required, up to two additional, external dispensing modules (DOS
modules) for liquid process chemicals can be fitted retrospectively.
External DOS modules are fitted by Miele Service or a qualified and
approved technician. Internal dispensing systems cannot be
retrospectively fitted.
DOS modules are supplied with their own installation instructions.
 Before fitting the DOS modules, compare the connection data
(voltage and frequency) on the data plates of the modules with that
on the data plate of your machine. If the data does not match, the
modules could sustain damage. If in any doubt, consult an
electrician.
 Power supply for DOS 1, detergent.
 Power supply connection for DOS 4, rinse aid.
 Connections for dispensing hoses.
Connect the module to the machine's power supply.

To connect the dispensing hose, release the hose clip on a free

connector and remove the safety cap.
Push the dispensing hose onto the connector and secure it with a

hose clip.
Unused connectors must be blanked off with safety caps to
prevent the leakage of wash fluid.
Dispensing systems".

Neutralizing agent

Neutralizing agent (pH setting: acidic) neutralizes any residues of
alkaline process chemicals on the surface of the load.
Neutralizing agent is dispensed automatically in the
phase after the main wash (see "Program charts"). The reservoir must
be filled and the dispensing system vented for this to occur.
Interim rinse
49