Dispensing/Dispensing Systems - Miele PG 8583 Operating Instructions Manual

Dispensing/dispensing systems

 Caution when handling process chemicals!
For all process chemicals, the process chemical manufacturer's safety instructions as
given on their safety data sheets must be observed.
Problem
The dispenser for powder
process chemicals
contains residue at the
end of the program.
The dispenser flap will not
close.
Refill DOS
Prog. start not possible.
Prime dispenser pump DOS
Dispensing system DOS
priming
Priming DOS canceled.
Priming must be repeated
Possible cause and solution
The dispenser was still damp when process chemicals
were added.
Make sure the dispenser is dry before adding powder

process chemicals.
The dispenser flap was blocked by items in the cabinet.
Rearrange the load so that the flap can open.

Process chemicals residue is blocking the latch.
Remove the process chemical residue.

During a program sequence, a low level of liquid chemical
agent in a container has been identified.
Replace the empty container with a full one.

A program cannot be started because:
- There is air in the dispensing system.
- The dispensing system has been completely emptied.
Check the level in the reservoir and refill or replace it with

a full container as necessary.
Vent the dispensing system.

This is not a fault.
The dispensing system is automatically being vented.
Wait until the venting process is finished.
Priming of the dispensing system was canceled because an
insufficient flow rate was identified. A dispensing hose may
be kinked or the siphon blocked.
Check the dispensing hose for kinks and leaks. Position

it so that it cannot become kinked.
Check the suction opening of the siphon for blockages

and remove them as necessary.
Start the priming process again.

Contact Miele Technical Service if there are leaks in the
dispensing hose or a fault with the siphon.
Frequently asked questions
127