Select Customer Calibration; 6.2.1 Active Customer Calibration - Mahr Millimar C 1200 Operating Instructions Manual

If a customer specific calibration is required, this can be entered as described below.
The calibration can be conducted with the connected probe or alteratively with a factory
standard (e.g. Mahr 1283 WN Factory Calibration, Order no. 5312833).
6.2 Customer calibration

6.2.1 Active customer calibration

– Press the ON / OFF key
The standard menu will appear on
=>
the screen
– Press the u key to select the System
menu
Select the submenu Customer
–
calibration with the q key
– Press 4 to confirm
– Select the submenu Enable with the
q key
– Press 4 to confirm or press Ó to
cancel selection
=> The symbol 4 depicts the currently
active correction
– To exit the input menu, press the ON /
OFF key.
34
Measurement Display Setup
Absolute mode
Customer calibration
Factory calibration
Factory Settings
Info
6 3
Measurement Display Setup
Customer calibration
Enable
Probe calibration
Factory standard calibration
Customer calibration Reset
6 3
Measurement Display Setup
Absolute mode
Customer calibration
Factory calibration
Factory Settings
Info
6 3
Mahr GmbH • Millimar C1200
System
ü
q p
System
q p
System
ü
q p