Excva Adjustment - Suzuki GSX-R1000 2007 Service Manual

6-10 EXHAUST SYSTEM

EXCVA ADJUSTMENT

1st step:
• Set the EXCVA to adjustment position. ( 6-4)
2nd step:
• Turn the mode select switch OFF.
• Turn the ignition switch ON to check the EXCVA operation.
• Turn the mode select switch ON.
• If C46 is not indicated on the LCD (DISPLAY), the adjustment
is correctly completed. In this case, it is unnecessary to pro-
ceed to 3rd step.
• If C46 is indicated, repeat the adjustment procedure from 3rd
and 4th step.
3rd step:
• This procedure is only required when C46 is indicated.
• Turn the ignition switch OFF.
• Insert the needle pointed probes into the back side of the
EXCVA position sensor coupler
• Disconnect the EXCVA motor coupler
• To set the EXCV to fully closed position, apply 12 V to " and
# terminals.
Positive wire –– " (P wire) terminal
Negative wire –– # (G wire) terminal
To prevent the motor damage, stop applying 12 V as
soon as the EXCV reaches fully closed position.
.
.
ON OFF
12 V