Chapter 3: First Time Setup; Overview; Thecus Setup Wizard - Thecus N2810 Series User Manual

Hide thumbs Also See for N2810 Series:
Table of Contents

Advertisement

Chapter 3: First Time Setup

Overview

Once the hardware is installed, physically connected to your network, and
powered on, you can configure the Thecus IP storage so that it is accessible to
your network users. There are two ways to set up your Thecus IP storage: using
the Thecus Setup Wizard or the LCD display (Depend on models). Follow
the steps below for initial software setup.

Thecus Setup Wizard

The handy Thecus Setup Wizard makes configuring Thecus IP storage a snap. To
configure the Thecus IP storage using the Setup Wizard, perform the following
steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
4. Select the Thecus IP storage that you like to configure.
5. Login with the administrator account and password. The default account
and password are both "admin".
For MAC OS X users, double click on Thecus Setup Wizard .dmg file.
Chapter 7: Troubleshooting
for assistance.
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents