Thecus N2810 Series User Manual page 107

A. Add a Stack Target Volume
From the figure above, click Create to access the stackable target device
configuration page. Please refer to the figure below:
With the added stack target you can "Enable" or "Disable" the stack target now or
later depending on usage required.
Next, input the target IP address of the stackable device and click the Discovery
Target button. The system will list available target volumes from the inputted IP
address.
Select Target IQN from drop list whic will be the stacking device after connected.
The Device Folder will become the network share name and will be displayed
through network access such as SMB. You may input Comment to tell the
subject of this stack folder if needed.
For this associated stacking device, you may need to input a valid user name and
password to validate your access rights. If there is no user name and password
needed to access target volume, then leave it blank.
From the figure above, the Device Folder is "kendo02". The figures below show
the result before and after via Microsoft Network Access when settings have been
completed.
107