Table of Contents
Advertisement
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the N8800SAS so that it is accessible to your network users.
There are two ways to set up your N8800SAS: using the Thecus Setup Wizard or
the LCD display. Follow the steps below for initial software setup.
Thecus Setup Wizard
The handy Thecus Setup Wizard makes configuring N8800SAS a snap. To configure
the N8800SAS using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
4. Select the N8800SAS that you like to configure.
5. Login with the administrator account and password. The default account and
password are both "admin".
For MAC OS X users, double click on Thecus Setup Wizard .dmg file.
Chapter 7: Troubleshooting
for assistance.
18
Advertisement
Table of Contents
