Table of Contents
Advertisement
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and
powered on, you can configure the N3200PRO so that it is accessible to your
network users. Follow the steps below for initial software setup.
Thecus Setup Wizard
The handy Thecus Setup Wizard makes configuring N3200PRO a snap. To
configure the N3200PRO using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
4. Select the N3200PRO that you like to configure. Press Next to continue.
For MAC OS X users, double click on Thecus Setup Wizard 1. 1.99.dmg
Chapter 8: Troubleshooting
for assistance.
14
Advertisement
Table of Contents
