Typical Setup Procedure - Thecus N2810 Series User Manual

Thecus IP storage at this point by clicking the Setup Other Device button.
Press Exit to exit the wizard.
NOTE

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your Thecus IP
storage for use on your network. Setting up the Thecus IP storage typically
follows the five steps outlined below.
Step 1: Network Setup
From the Web Administration Interface, you can configure the network settings of
the Thecus IP storage for your network. You can access the Network menu from
the control panel.
Step 2: RAID Creation
Next, administrators can configure their preferred RAID setting and build their
RAID volume. You can access RAID settings from the control panel of the Web
Administration Interface by navigating to Storage Management > Disk and
RAID.
Step 3: Create Local Users or Setup Authentication
Once the RAID is ready, you can begin to create local users for Thecus IP storage,
or choose to setup authentication protocols such as Active Directory (AD).
Step 4: Create Folders and Set Up ACLs
Once users are introduced into your network, you can begin to create various
folders on the Thecus IP storage and control user access to each using Folder
Access Control Lists.
Step 5: Start Services
Finally, you can start to setup the different services of Thecus IP storage for the
users on your network.
The Thecus Setup Wizard is designed for installation on systems running
Windows XP/2000/vista/7/8/10 or Mac OSX or later. Users with other operating
systems will need to install the Thecus Setup Wizard on a host machine with
one of these operating systems before using the unit.
31