Chapter 3: First Time Setup; Overview; Thecus Setup Wizard - Thecus N7700 User Manual

Chapter 3: First Time Setup

Overview

Once the hardware is installed, physically connected to your network, and
powered on, you can configure the N7700 so that it is accessible to your network
users. There are two ways to set up your N7700: using the Thecus Setup
Wizard or the LCD display. Follow the steps below for initial software setup.

Thecus Setup Wizard

The handy Thecus Setup Wizard makes configuring N7700 a snap. To configure
the N7700 using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
4. Select the N7700 that you like to configure.
5. Login with the administrator account and password. The default account
and password are both "admin".
For MAC OS X users, double click on Thecus Setup Wizard 1.1.99.dmg
Chapter 8: Troubleshooting for assistance.
16