Chapter 3: First Time Setup; Overview; Thecus Setup Wizard - Thecus N4100PRO User Manual

Chapter 3: First Time Setup

Overview

Once the hardware is installed, physically connected to your network, and powered
on, you can configure the N4100PRO so that it is accessible to your network users.
There are two ways to set up your N4100PRO: using the Thecus Setup Wizard or
the LCD display. Follow the steps below for initial software setup.

Thecus Setup Wizard

The handy Thecus Setup Wizard makes configuring N4100PRO a snap. To configure
the N4100PRO using the Setup Wizard, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
NOTE
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
For MAC OS X users, double click on Thecus Setup Wizard 1.2.0.dmg
Chapter 8: Troubleshooting for assistance.
15