Dhcp Server - Thecus N2810 Series User Manual

Basic Setting
MAC address
IP
Device speed
Link status
Jumbo Frame
Note
IPv4/IPv6
Mode
IP address
Netmask
Gateway
NOTE
WARNING

DHCP Server:

The network port of Thecus IP storage can be acted as DHCP server if associated
NIC has been set-up to a static IP. Please fill in the fields to complete setting.
DHCP Configuration
Item
Enable IPv4/IPv6 DHCP
Server
Start IP (IPv4)
End IP in (IPv4)
MAC address of the network interface.
IP address of associate NIC interface.
Display associated NIC port link speed.
Display associated NIC port link status.
Input Jumbo Frame rate from drop down list, default is 1500
Input the description of associated network port if any
Setting IP address from manual input or DHCP server .
It can choose a static IP by manually input or Dynamic IP from DHCP
server.
Input IP address if manually input has selected or displayed by granted
from DHCP server
Input netmask if manually input has selected or displayed by granted
from DHCP server
Input gateway if manually input has selected or displayed by granted from
DHCP server
• Only use Jumbo Frame settings when operating in a Gigabit environment
where all other clients have Jumbo Frame Setting enabled.
• Proper DNS setting is vital to networks services, such as SMTP and NTP.
Most faster Ethernet (10/100) Switches/Routers do not support Jumbo Frame and will not be
able to connect to your Thecus NAS after Jumbo Frame is turned on.
Description
Enable or disable the IPv4/IPv6 DHCP Server to automatically
assign IP address to PCs connected to associate NIC
interface.
Specifies the lower IP address of the DHCP range.
Specifies the highest IP address of the DHCP range.
49