Table of Contents
Advertisement
Chapter 3: First Time Setup
Overview
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the Thecus VisoGuard so that it is accessible to your network
users. There are two ways to set up your Thecus VisoGuard: using the Thecus
Setup Wizard or the LCD display. Follow the steps below for initial software
setup.
Thecus Setup Wizard
The handy Thecus Setup Wizard makes configuring Thecus VisoGuard a snap. To
configure the Thecus VisoGuard using the Setup Wizard, perform the following
steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to
4. Select the Thecus VisoGuard that you like to configure.
5. Login with the administrator account and password. The default account
and password are both "admin".
Chapter 7: Troubleshooting
for assistance.
24
Advertisement
Table of Contents
