HP FlexFabric 12900 Series Configuration Manual page 168

The service provider assigns VLAN 100 to a company's VLANs 10 through 50.
•
• VLAN 3000 is the dedicated VLAN of the company on the service provider network.
Configure QinQ on PE 1 and PE 2 to provide Layer 2 connectivity for CVLANs 10 through 50 over the
service provider network.
Configure VLAN transparent transmission for VLAN 3000 on PE 1 and PE 2 to enable the hosts in VLAN
3000 to communicate without using an SVLAN.
Figure 45 Network diagram
Site 1
VLANs 10 to 50, 3000
Configuration procedure
1. Configuring PE 1:
# Configure Ten-GigabitEthernet 1/0/1 as a trunk port, and assign it to VLANs 10 through 50,
VLAN 100, and VLAN 3000.
<PE1> system-view
[PE1] interface ten-gigabitethernet 1/0/1
[PE1-Ten-GigabitEthernet1/0/1] port link-type trunk
[PE1-Ten-GigabitEthernet1/0/1] port trunk permit vlan 100 3000 10 to 50
# Set the PVID to 100 on Ten-GigabitEthernet 1/0/1.
[PE1-Ten-GigabitEthernet1/0/1] port trunk pvid vlan 100
# Enable QinQ on Ten-GigabitEthernet 1/0/1.
[PE1-Ten-GigabitEthernet1/0/1] qinq enable
# Configure Ten-GigabitEthernet 1/0/1 to transparently transmit frames from VLAN 3000.
[PE1-Ten-GigabitEthernet1/0/1] qinq transparent-vlan 3000
[PE1-Ten-GigabitEthernet1/0/1] quit
# Configure Ten-GigabitEthernet 1/0/2 as a trunk port, and assign it to VLAN 100 and VLAN
3000.
[PE1] interface ten-gigabitethernet 1/0/2
[PE1-Ten-GigabitEthernet1/0/2] port link-type trunk
[PE1-Ten-GigabitEthernet1/0/2] port trunk permit vlan 100 3000
[PE1-Ten-GigabitEthernet1/0/2] quit
2. Configuring PE 2:
# Configure Ten-GigabitEthernet 1/0/1 as a trunk port, and assign it to VLANs 10 through 50,
VLAN 100, and VLAN 3000.
PE 1
XGE1/0/2
VLANs 100 and 3000
XGE1/0/1
Service provider network
CE 1
PE 2
XGE1/0/2
XGE1/0/1
CE 2
VLANs 10 to 50, 3000
160
Site 2